ILLUSION2BEAM - FREE 3D ILLUSION SAMPLES
Make your own designs: https://www.depth2beam.com/illusion2beam/

Each folder has 3 files:
  _Laser.png         The file you engrave (white = no burn, black = deepest burn)
  _Cut_Line.svg      Outline for cutting the piece out
  _Wood_Preview.png  How the finished design is meant to look (preview only, don't engrave it)

QUICK START (LightBurn)
1. Import the Laser PNG and the Cut Line SVG. Both open at 8 in on the long side and line up exactly.
   Keep them together if you resize (lock the aspect ratio).
2. Image mode: Stucki (CO2) or Jarvis (diode). Don't use Grayscale.
3. Run a small test crop on scrap from the same board first.
4. Engrave first, then cut. Put the cut layer below the image layer in Cuts / Layers.
5. Clean the soot off with isopropyl alcohol and a soft brush.

Best size: up to about 8 in on the long side.
Best wood: light, even-grain wood such as basswood, alder or laser-grade birch plywood.
Full tested settings are in the Laser Engraving Starter Guide PDF in this folder.

Free for personal use and for selling your engraved pieces.
Please don't resell or share the digital files themselves.
Post a photo of your burn, we'd love to see it!
